Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 66

13 Status LCD
This display shows you your URSA Mini Pro's essential settings at a glance, without
needing to open the internal touchscreen. This screen is designed to be visible even in
bright daylight. The following information is available:
Timecodes
FPS, Shutter Angle, White Balance
Timecodes
Your URSA Mini Pro displays three timecodes. If you have an external timecode
connected, this will be shown under the 'ext' indicator in the top left of the status LCD.
Your URSA Mini's internally generated timecode is shown next to this under the 'gen'
indicator. Both the external and generated timecodes are shown in hours, minutes,
seconds and frames.
The larger, main timecode indicator displays your current timecode as either clip
duration or timecode. You can switch between these two display modes by pressing
the 'timecode' button underneath the status LCD.
Battery indicator
If your URSA Mini Pro is running on battery power, this indicator displays remaining
battery life in 25% increments. Each of the battery indicator's four bars corresponds to
25% battery life remaining. When your battery drops below 20% charge, the color of the
status LED, near the record button begins to flash. It will alternate slowly between red
and orange during recording and alternate between white and orange during
standby mode.
If the mains power connector is plugged into your camera, the battery indicator
shows as full.
FPS, Shutter Angle, White Balance
The 'FPS,' 'SA,' and 'WB' indicators display your camera's current frame rate, shutter
angle and white balance. The 'fps' indicator shows the current sensor frame rate.
For more information on sensor and project frame rates, see the 'touchscreen controls'
section in this manual.
ISO Iris
Battery indicator
Record Low record
indicator time remaining
Card indicator
URSA Mini Pro Control Buttons
Dropped
frame
indicator
Audio meters
66