Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 173

Batt 2
Batt 4
GND 6
Monitor 1 8
GND 10
+12V Out 12
The rear view of the adapter's connector housing.
Refer to the wire configuration table for a description of each pin
Wire Configuration Table
Pins Signal
1, 2, 3, 4 Batt
5, 6, 9, 10 GND
7 Monitor0
8 Monitor1
12 +12 V out
11 EnableN
Each Batt and GND pin supports 3 amps. Make sure all Batt and GND pins are connected.
To monitor the battery status using Anton Bauer, IDX, or Blueshape plates, follow the
connection table below:
Anton Bauer Connect the blue/white striped wire to the housing blue wire at pin 7.
Connect the green wire to the housing green wire at pin 8,
IDX
and the gray wire to the housing blue wire at pin 7.
Connect the blue wire labelled 'SMBC' to the housing green wire at pin 8.
Blueshape
Connect the brown wire labelled 'SMBD' to the housing blue wire at pin 7.
Secure any unused wires by cutting them as close as possible to the rear of the
adapter connector.
Color Direction
Red To URSA
Black –
Blue To URSA
Green To URSA
Orange From URSA
White To URSA
1 Batt
3 Batt
5 GND
7 Monitor0
9 GND
11 EnableN
Description
12 V to 20 V
–
Analog battery level or open drain data
line (20 V max)
Open drain clock line (3.4 V max)
12 V regulated output 1.5 A max (18 W)
Connect to GND to enable +12 V out.
Leave floating if +12 V out is not required.
Mounting Batteries 173