Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 262

How to Update the Camera Software
The Mini-B USB 2.0 port is used to update the
camera software and can be found above the
memory card slots on Blackmagic URSA Mini
After installing the latest Blackmagic Camera Setup utility on your computer, connect a
USB cable between the computer and your Blackmagic URSA Mini. On Blackmagic URSA Mini,
the USB port is located on the left side panel above the memory card slots. Simply open the
rubber cap to access the port.
Launch the Blackmagic Camera Setup utility and follow the on screen prompts to update the
camera software. It's important to note that updating your camera software erases any presets
and custom LUTs, and resets all settings. It is a good practice to export them to a memory card
as a backup before performing a software update. After a software update, you can restore
your presets and LUTs quickly by importing them from the memory card. You are also advised
to perform a black shading calibration.
The USB-C port is used to update the camera software
and can be found above the memory card slots, next to
the media selection switch on Blackmagic URSA Mini Pro
Blackmagic Camera Setup Utility 262