Roger Technology B70-2DCHP Instrucciones Y Advertencias Para El Instalador página 25
Ocultar thumbs
Ver también para B70-2DCHP:
- Instrucciones y advertencias para el instalador (168 páginas) ,
- Instrucciones y advertencias para el instalador (37 páginas)
Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TABLE OF CONTENTS
1
Introduction to the instructions and
warnings
2
Product technical characteristics
3
3.1
3.1.1
3.2
3.3
3.4
Radio receiver coupling
3.5
3.5.1
3.5.2
3.5.3
3.5.4
4
4.1
4.2
4.3
4.4
4.5
4.6
5
6
7
8
Pictures and schemes
2
Technical product characteristics B70/2DCHP
SUPPLY VOLTAGE
MAXIMUM POWER CONSUMPTION
CONNECTIBLE MOTORS
POWER SUPPLY MOTORS
MOTOR TYPES
MOTOR CONTROL TYPE
RATED POWER FOR MOTOR
MAXIMUM POWER FOR MOTOR
MAXIMUM POWER FLASHING
INTERMITTENT FLASHING
MAXIMUM POWER COURTESY LIGHT
GATE OPEN LIGHT POWER
ELECTRIC LOCK POWER
ACCESSORIES OUTPUT POWER
OPERATING TEMPERATURE
DEGREE OF PROTECTION
PRODUCT DIMENSIONS
pag.
1
Introduction to the instructions and warnings
25
This manual is only intended for personnel
25
qualified to perform the installation.
26
No information contained in this document may be
26
considered of interest to the end user.
27
This manual refers to control panel B70/2DCHP for
27
automations comprising 1 or 2 ROGER brushless
27
motors and should not be used for other motors.
27
28
28
29
29
WARNINGS
29
To avoid the risk of electrocution and physical injury
29
always cut the power before intervening on the
30
device.The installation must only be carried out by
31
qualified service personnel according to applicable
31
regulations.Make the connections to the currents
32
and voltages required with the appropriate cables;
32
observe the product's technical characteristics.
Check the conformity of the earth system and the
32
continuity between the earth on the motor side and
33
the control unit's terminal block.
33
The same type of motors must be used for both
33
wings.The slowdowns can be set independently:
43
ensure that they are appropriate for the type of
43
installation, in order to prevent the wings from
43
overlapping.
130
230Vac ± 10% 50Hz
600W
2
36Vac with self-protected invert
brushless sinusoidal (ROGER BRUSHLESS)
Field oriented control (FOC), sensorless
60W
250W
25W (24Vdc)
50%
100W 230Vac - 40W 24Vac/dc (pure contact)
3W (24VDC)
15W (12VDC)
10W (24VDC)
-20°C ... +60°C
IP54
Dimension in mm. 330 x 230 x 115 Weight: 3,9Kg
Read the
instructions
carefully before
starting the
installation.
ELECTROCUTION
HAZARD
EN
25
Publicidad
Capítulos
Tabla de contenido
