Motor Model; Automatic Reclosing After The Pause Time; Reclosing After Blackout - Roger Technology B70-2DCHP Instrucciones Y Advertencias Para El Instalador

parameter number
selectable values
A1 04

Motor model

01
piston BM20 BRUSHLESS
02
piston BR20 BRUSHLESS
03
articulated arms BH23 BRUSHLESS
04
underground motor BR21 BRUSHLESS
NOTE: parameter
The correct selection of the motor is critical for proper operation of the automation; an incorrect
setting of parameter
create occasional malfunctions which are difficult to fathom.
So pay a lot of attention to the value of this parameter; and because of its importance, when doing a
factory parameters restore this is the only parameter not to be changed.
A2 00

Automatic reclosing after the pause time

00
OFF (doesn't automatically relock)
01 15
NUMBER of reclosure attempts (interrupted by photocell) before finally staying open
-
99
try to close without limitation to the number of attempts
NOTE: parameter
To enable automatic reclosing you must set this parameter to a different number from
parameter the value
01
between
setting the value
would re-open but would no longer close (only performs one reclosing attempt).
NOTA: the value of the parameter
49
has a maximum value equal to that of parameter
A3 00

Reclosing after blackout

00
OFF (does not reclose when the power is restored)
01
ON (recloses when the power is restored)
NOTE: parameter
If this parameter is set to
5 s (even if not enabled on parameter
during the reclosing because it guarantees that the gate is closed when the supply voltage is restored.
After the blackout the position of the wings is unknown, and if the phase shift in closure is enabled,
reclosing takes place one wing at a time in "position recovery" mode.
34
A2 00
01
C-
in simplified mode
A1
may prevent operation but also in certain not particularly onerous cases,
1-
in simple mode.
99
will it always reclose after the pause time. However, if you set a number
15
and , is the maximum number of attempts at reclosing carried out. For example, by
01
, f a person crosses the ray of the reversal photocells when reclosing, the wings
3-
in simplified mode.
01
lthe control unit, when on, performs the reclosing after a pre-flashing lasting
standard
production value
Parameter description
00
function associated with the value 00
15
function associated with values from 01 to 15
-
49
is subordinate to that selected for parameter
a2
A5
). This feature is useful when there is no longer the supply voltage
.
00
; only by
a2
; parameter