Impact Force Separate Adjustment Motor 2; Acceleration When Starting Motor 1; Pressure Surge; Rated Speed - Roger Technology B70-2DCHP Instrucciones Y Advertencias Para El Instalador

33 10

Impact force separate adjustment motor 2

motor torque reduction: 1 = -35%, 2 = -25%, 3 = -16%, 4 = -8%
01 09
5 = the motor torque is that of the factory
-
motor torque increase: 6 = +8%, 7 = +16%, 8 = +25%, 9 = +35%
10
the torque of both motors is determined by parameter
10
Value establishes there is a unique identical adjustment for motor 1 and 2 (determined by
30
par. ); instead, if you want to adjust the impact force separately for the two motors, you need to
33
set par. with a different lesser value of
In this case, the par.
34 08

Acceleration when starting motor 1

35 08
Acceleration when starting motor 2
01 10
1 = quick start ... 10 = very slow start
-
Can be set separately for both motors, thus adapting the control to the mechanical situation;
however you should always make sure the choice is appropriate, and does not cause wings which
may have had a phase shift to overlap.
A low value (
speed more slowly, thus allowing a more gentle and gradual start of the wing.
NOTE: these parameters can be changed even after you have programmed the stroke.
38 00

Pressure surge

00
ENABLE
01
DISABLE
Enabled in order to facilitate the release of the electric lock, which could be hindered by the leafs
that press on the coupling point (for example, due to the wind): the opening operation is preceded
by a short closing for no more than 4 seconds.
Enabling the pressure surge also automatically enables the electric lock.
The pressure surge is only performed when starting from the fully closed position, every opening operation is
performed until the position of the wings is known by carrying out a closing movement for 1.5" before opening.
40 05

Rated speed

01 05
1 = minimum speed ... 5 = maximum speed
-
01
The values
maximum speed.
49 00
Automatic reclosing attempts after safety edge or the anti-crushing protection intervention
00
does not automatically reclose after the safety edge or the anti-crushing protection intervention
01 03
number of attempts at reclosing
-
If the value exceeds that of parameter
a2
. Only recloses after the impact if it is moved back until fully open (check the value of parameter
50 00

Mode if photocell FT1 is interrupted when opening

00
IGNORE, no action or FT1 not installed
01
STOP, the gate remains stationary until the next command
02
REVERSE IMMEDIATELY, thus closing
03
TEMPORARILY STOP, the beam released, it continues to open
04
INVERT WHEN RELEASED, the beam released, it reverses thus closing
38
33
function is identical to that described for par.
01
) involves rapid acceleration, while a high value (
02 03 04
- - - -
10
.
05
respectively correspond 60%, 70%, 80%, 90% e 100% of the
a2
, it will be automatically considered to be equal to that of parameter
30
30
, but is only limited to motor 2.
10
) means reaching the operating
27
).