Standby Mode - Roger Technology B70-2DCHP Instrucciones Y Advertencias Para El Instalador

N.B.: the sequence of parameters for simplified
mode is not the same as that of extended mode,
therefore always refer to the instructions or the
label on the inside of the cover.
3.5.3

Standby mode

After 30 minutes of inactivity, the control unit enters
standby mode, and the display only indicates a
STANDARD
PARAMETER
AND VALUE
0- 02
Number of motors
1- 00
Automatic reclosing
2- 30
Pause time
3- 00
Emergency blackout
4- 05
Phase shift closing M1
5- 00
Pre-flashing
6- 00
Step-by-step mode
7- 00
Flashing configuration
8- 00
Enabling limit switch
Impact of force level
9- 15
motor 1
Impact of force level
A- 15
motor 2
b- 00
Pressure surge
C- 04ù
Motor model
30
FUNCTION
DISPLAY
01 - 15 number of attempts to reclose (interrupted by
00 - 90 seconds of pause
92 - 99 2 minutes...9 minutes of pause
01 - 30 phase shift seconds
01 - 10 pre-flashing seconds
01 - 10 low torque motor
11 - 19 medium torque motor
01 - 10 low torque motor
11 - 19 medium torque motor
flashing dot.
The activation of standby automatically resets the
simplified parameters mode.
The mode remains at rest on the display, but the
control unit is always ready to perform commands;
to turn the display back on you have to press one of
the buttons UP,DOWN,+,-.
VALUE
ON
1 motor
01
2 motors
02
deactivated
00
photocell) before finally staying opened
always tries to reclose, without limitation
99
deactivates the reclosing when power returns
00
enables the reclosing when power returns
01
deactivated
00
deactivated
00
5 seconds of pre-flashing only when closing
99
opens stops closes stops opens stops closes ..
00
condominium, refreshes the pause time
01
condominium, closes from completely open
02
opens closes opens closes
03
opens closes stops opens
04
constant (the light flashes)
00
slow flashing while active
01
slow flashing while opening, fast while closing
02
no limit switch connected
00
limit switch on opening connected
01
1 minimum impact force ... 10 max. impact force
11 minimum impact force ... 19 max. impact force
Maximun torque motor
20
Without anti-crushing protection (obligatory safety edges)
1 minimum impact force ... 10 max. impact force
11 minimum impact force ... 19 max. impact force
Maximun torque motor
20
Without anti-crushing protection (obligatory safety edges)
deactivated
00
enabled
01
piston BM20 BRUSHLESS
01
piston BR20 BRUSHLESS
02
articulated arm BH23 BRUSHLESS
03
underground motor BR21 BRUSHLESS
04
DESCRIPTION