Flashing Configuration; Duration Courtesy Light; Clock Configuration; Closure Enabling Guaranteed - Roger Technology B70-2DCHP Instrucciones Y Advertencias Para El Instalador

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 90
78 00

Flashing configuration

00
FIXED (the intermittent operation is carried out by the electronics of the flashing)
01
slow intermittent activation
02
slow intermittent activation when opening; quick intermittent activation when closing
NOTE: parameter
The flashing starts when there is a movement phase; you can have continued activation (for flashing
lights with electronics timed on-board) or controlled directly by the control unit (for flashing lights
with a simple lamp).
79 60

Duration courtesy light

00
OFF (deactivated)
01
PULSE (brief activation at the start of each operation)
02
ACTIVE DURING THE ENTIRE OPERATION
03
90
SECONDS OF ILLUMINATION AFTER THE END OF THE OPERATION
-
92
99
FROM 2 TO 9 MINUTES AFTER THE END OF THE OPERATION
-
80 00

Clock configuration

00
When the clock input is closed (ORO) it opens and then ignores all the commands
01
When the clock input is closed (ORO) it opens and accepts all the commands
If you choose par.
81 00

Closure enabling guaranteed

00
DEACTIVATED (NOTE: as a result par
01
ENABLED
Enabled when you want the wings to never remain open in unexpected situations; for example for
an activation not due to a step-by-step command keeping away from the gate while it was closing,
or due to a strong gust of wind which activates the anti-crushing protection, the gates would remain
open while waiting for a new command.
After a time set by parameter
A5
from par.
) and then by a closing command.
The function will only be able to intervene if a STOP command has been given (from the push-button
pad) or the safety edge has intervened and the number set by parameter
control of the position has been lost (needs to be repositioned).
82 01

Waiting time to activate the closure guaranteed

01
90
SECONDS
-
92
99
from 2 to 9 MINUTES
-
90 00

Restoring standard factory values

After having displayed the number
display shows
(indicated next to the parameter numbers).
A1
WARNING!
WARNING! After the reset, check that the parameters are adjusted to the type of installation.
7-
in simplified mode
A1 03
72 01
and
82
the control unit activates a pre-flashing of 5" (even if not enabled
90
rE S-
flashing which signals a standard factory values reset has taken place
is not restored
the parameter is not displayed.
82
is not displayed)
, press the + and - buttons simultaneously for 4 seconds, the
a2
, has been exceeded, or
41

Publicidad

Tabla de contenido
loading

Tabla de contenido