Chapter 3 - First Steps; Switch On The Autoclave; Opening And Closing The Door; Preparing The Feed Water - Sirona DAC PROFESSIONAL Instrucciones De Uso

Chapter 3 – First steps

Switch on the autoclave

The autoclave is switched on at the power switch (page 8, Fig. 1/4).
After switching the autoclave on at the power switch, the display shows the message: Unlock the door
with "+" key, if the door is closed, alternating with the initial operating state.
NOTE
Immediately after switching the autoclave on for the first time and before the initial start-up, all
accessory parts must be removed from the chamber.

Opening and closing the door

The door can only be opened when the message: Acknowledge with "+" / Unlock door with
"+" key appears on the display.
Press the (+) key. After an audible click, you can open the door.
1.
To close the door, press it gently against the chamber flange while pushing the sliding latch down.
2.

Preparing the feed water

Using the internal water storage tank
If the feed water is supplied via the internal water storage
tank, this must be manually filled from time to time. The
autoclave displays an appropriate message when this is
necessary.
The internal water storage tank holds a maximum of 5
liters. This quantity of feed water is sufficient for up to 7
sterilization cycles.
To fill the water storage tank with fresh feed water, remove
the lid and fill the tank (right chamber) up to the MAX mark
with fresh feed water:
Setting the feed water supply to the autoclave
To supply the feed water via the internal water storage tank, the function INTERNAL must be set. To
supply the feed water via a water preparation unit, the function EXTERNAL must be set.
Select the Function set-up menu by pressing the (+) and (-) keys at the same time. The display
1.
shows the message Function: Last batch no.
Navigate to the message: Function: Feed water supply on the display using the (+) or (-)
2.
keys.
Press the (P) key. The display shows the currently selected option.
3.
Press the (P) key again to change to the desired setting (INTERNAL/EXTERNAL).
4.
Press the (S) key to save the setting and exit the menu.
5.
By pressing the (S) key again, you leave the menu completely and return to the initial operating state of
the display.
Chapter 3 – First steps
11