Setting The Date And Time - Sirona DAC PROFESSIONAL Instrucciones De Uso

Chapter 3 – First steps
Using a water preparation unit
To use a water preparation unit, please follow the instructions in the service manual.
NOTICE
Please consult Sirona first if you would like to use a water preparation unit from another
manufacturer.
Failure to comply with these instructions can damage the autoclave and/or the items to be
sterilized.

Setting the date and time

For flawless batch documentation, the date and time of the autoclave must be set correctly. Please note
the switch to and from daylight savings in spring and fall as this is not done automatically. Set the date and
time as described below:
Select the Function set-up menu by pressing the (+) and (-) keys at the same time. The display
1.
shows the message Function: Last batch no.
Navigate in the "Function" menu using the (+) or (-) keys until you reach the message:
2.
Press the (P) key to confirm. The current hour is shown.
3.
Using the (+) or (-) keys, select between the following setting options: hour, minute, second, day,
4.
month, year.
To set the parameter "hour," for example, press the (P) key to confirm.
5.
The current value on the display flashes.
With the (+) and (-) keys, you can increase or decrease the value.
6.
To save the value, confirm with the (P) key.
7.
The value currently set on the display no longer flashes.
To adjust the other parameters, proceed as described above.
After the setting is complete, press the (S) key to leave the menu.
8.
The display shows the message Function: Date/time.
After pressing the (S) key again, you leave the menu completely and the display shows the initial
9.
operating state again.
12
Function
Date/time
Start-Stop
Programm