Sirona DAC PROFESSIONAL Instrucciones De Uso página 97

Vacuum test
Program phase
1. Evacuation
2. Equilibration time
3. Measurement period
3. Ventilation
4. End of test
Summary of the sterilization programs
The results in this table show which tests the autoclave underwent. The labeled fields indicate compliance
with all the applicable sections of the
DIN EN 13060 standard.
Type testing
Program type as defined by
DIN EN 13060
Dynamic pressure testing of
the sterilization chamber
Air leak
Empty chamber test
Solid load
Porous partial load
Porous full load
Hollow body B
Hollow body A
Single wrapping
Multiple wrapping
Drying
solid load
Drying
porous load
Sterilization temperature
Sterilization pressure
Sterilization time
Description
The chamber is evacuated until the pressure for the vacuum test is reached.
This is followed by an equilibration time of five minutes.
The measurement period is ten minutes. In this time the pressure increase in
the chamber is measured. The evacuation pressure and the equilibration time
or measurement period are shown on the display.
After the measurement period has elapsed, the chamber is ventilated. A
message with the details of the leak rate is then shown on the display.
If the leak rate is too high, that is, it is greater than 1.3 mbar, the message also
indicates this.
On the display the current batch number for the day alternates with
"Acknowledge with "+" key". After pressing the (+) key, you can open the door.
Universal Quick program
program B
Type B Type B
X X
X X
X X
X X
X
X
X X
X X
X
X X
X
134 °C 134 °C
2/29 2/29 bars/psi
bars/psi
5.5 min 3.5 min
Quick program Gentle
S program
Type S Type B
X X
X X
X X
X X
X
X
X
X
X
X
X X
X
134 °C 121°C
2/29 bars/psi 1 bar
3.5 min 20.5 min
Chapter 9 – Function descriptions
Prion
program
Type B
X
X
X
X
X
X
X
X
X
X
X
134 °C
2/29 bars/psi
20.5 min
39