Select Automatic Preheating; Start Program - Sirona DAC PROFESSIONAL Instrucciones De Uso

Select automatic preheating

In the factory setting the automatic preheating is activated. This function heats the chamber of the
autoclave to the preheat temperature for that particular program prior to starting a program or holds the
chamber at this temperature between two program steps. This shortens the cycle times.
NOTE
The autoclave must remain switched on to use the automatic preheating function.
To change this setting, please proceed as follows:
Select the "Function" set-up menu by pressing the (+) and (-) keys at the same time until
1.
the message Function: Last batch no. appears on the display.
Using the (+) or (-) keys, navigate to the message:
Press the (P) key to confirm. The display shows the currently set option, e.g., Preheating yes.
2.
If you press the (P) key again the message on the display switches to Preheating no. The
3.
preheating function is deactivated.
To leave the Function: Auto. preheating menu and return to the initial operating state,
4.
press the (S) key 2×.
NOTE
Sirona recommends activating automatic preheating.

Start program

WARNING
Unsupervised operation of electrical equipment, such as this autoclave, is done at your own risk.
Sirona does not accept liability for any damage occurring as a result of unsupervised operation.
If you have selected a program using the program selection keys, the sterilization temperature is shown on
the display in addition to the program you have selected. You can also see whether the particular program
is suitable for wrapped or unwrapped items.
Press the (S) key to start the program.
1.
The autoclave checks the pumping of the feed water and its conductivity.
Function:
Autom. Preheating
Universal program
134 °C wrapped
Chapter 4 – Sterilizing
Start-Stop
Programm
Start-Stop
Programm
19