Delayed Log Output - Sirona DAC PROFESSIONAL Instrucciones De Uso

NOTE!
If immediate output of a log is not possible, e.g., because the activated output medium is not
connected, a warning appears. Sirona recommends that you use the immediate log output.

Delayed log output

You can output logs later and independent of when a program ended. You can choose whether selected or
all saved logs (up to 40 logs) should be printed. Use the connected output medium, e.g., the log printer.
Print selected logs
To print selected logs from particular programs at a later point, proceed as follows:
Select the "Function" set-up menu by pressing the (+) and (-) keys at the same time. The display
1.
shows the message Function: Last batch no.
Navigate using the (+) or (-) keys until the message: Function: Log output is displayed and
2.
press the (P) key.
The display shows the Log output – Output medium menu.
Navigate using the (+) or (-) keys until you see the message: Output last cycle: No. 40
3.
(as an example for no. 40).
Press the (P) key. The current log number flashes.
4.
To output a log from a different cycle, navigate using the (+) or (-) keys until you reach the desired
5.
number, 25 in this example.
Press the (P) key to start the output of the selected program. The display shows the message
6.
Output.
After successful output, the display again shows the previous setting with the message:
To output additional logs, repeat the last three steps.
To leave the submenu without outputting the log, press the (S) key.
7.
To leave the menu after successful output, press the (S) key. The display shows the message
8.
Function: Log output.
By pressing the (S) key again, you leave the menu completely and return to the initial operating state of
the display.
Last cycle
output: No. 25
Start-Stop
Programm
Chapter 5 – Logging
27