Power Unit; Inspection Of Cylinder Head - TOHATSU EverRu MX 18E2 Manual De Servicio

Power Unit

3
5-40

13) Inspection of Cylinder Head

1.
2.
3.
2
1
4.
Remove carbon deposit in the combustion chamber of
cylinder head, and check the interior for degradation,
damage and other defects.
Check water jacket interior for deposits.
When cleaning mating surfaces of cylinder head
by using a means such as a scraper or wire
brush, be careful not to scratch the surfaces.
2 and thickness gauge 3 to check
Use straight edge
distortion of cylinder head 1 in the directions shown.
Repair or replace if the distortion is over the specified limit.
Thickness Gauge :
Commercially Available Item
Functional Limit :
0.03 mm (0.00118 in)
If the distortion is over the limit, lap the component by
using a sheet of sand paper #240 - #400 placed on a
surface plate or thick place glass and moving it on the
paper drawing the letter "8" on it. Finish by using sand
paper #600 - #1000.
GB
2st X18E2 2012