Publicidad
Idiomas disponibles
Idiomas disponibles
5.2
Setting up, connecting and switching on the incubator
5.2.1
Installing the incubator
5.2.2
Incubator connection
Power supply connection
AB69601en
NOTICE
If there is a cold-to-warm temperature difference,
there is a danger that condensate will form on the
electrical components of the incubator.
The forming condensate can cause a short circuit.
Allow the incubator to acclimate for at least three
hours at the installation site before putting the device
into operation.
■
Please inspect the device for mechanical integrity, and ensure that
all items in the delivery scope have been delivered by checking
against your order.
■
When choosing its place of installation, bear in mind the weight
of the incubator when loaded, and its loading process; see
Chapter 9 'Technical data' on page 71 .
⮫
■
The installation location must not be in an area of direct sunlight
or near to any sources of heat.
■
The device must not be installed in the following places:
–
outdoors,
–
in damp places or places which can easily become flooded,
–
near flammable or volatile substances,
–
near acids or in corrosive environments.
■
Ventilation openings must not be blocked. A clearance of 100
mm must be maintained from the ventilation slots and ventilation
openings of the incubator.
The room's ceiling height must be at least 300 mm higher than
the height of the device.
1.
Position and level the incubator on a flat, non-combustible sur-
face in a stable position.
2.
Adjust the height of the shelves and drawers as needed.
DANGER
A hazard is posed by a damaged mains supply line.
There is an electric shock hazard for personnel.
−
Check the incubator and the mains supply line for
damage. If damage is discovered, the incubator
must not be operated.
−
The incubator may only be operated at a socket
with a personal protection switch.
02.2023 / Rev. --
Commissioning
19 / 82
Publicidad
