Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
6.3
Door locking mechanism
6.4
Standard check before every use
6.5
Switching on the incubator
6.6
Unit operation
6.6.1
External memory (USB flash drive)
26 / 82
The incubator can be locked to prevent unauthorised persons from
opening the door. Individual locking cylinders are used. If the keys
are lost, the lock can be changed by the manufacturer's service
department.
Before locking, ensure you are completely certain
that there are no persons inside the incubator.
1.
Insert the key in the lock.
2.
Turn the key to the left to lock the incubator.
3.
Turn the key to the right to unlock the incubator.
The outer door is equipped with an open door sensor. If the
door is not closed properly, an audible alarm is triggered. The
door alarm delay can be set as follows: 30s, 1 min, 2 min, 5
min or 10 min.
Before each use of the incubator, ensure that
■
the mains voltage corresponds to the specification on the rating
plate;
■
the incubator is level and sits securely on its feet;
■
the door closes tightly;
■
there are no outstanding alarm or error messages;
■
the ventilation slots of the incubator are free from obstructions;
■
the safety distances are complied with;
■
the incubator exhibits no obvious damage.
–
This applies to the incubator itself as well as to all accessories
and optional equipment.
Switch the incubator on by actuating the unit switch.
�� The control unit starts up.
The start screen is displayed.
This symbol means that a given window can be moved in the direc-
tion shown in the picture.
The external memory (USB flash drive) can be used to copy data
record, event log and service log from the unit's internal memory.
Before first use, the USB flash drive must first be formatted with the
02.2023 / Rev. --
AB69601en
Publicidad
