Publicidad
Idiomas disponibles
Idiomas disponibles
5.3.1
Standard slide-in modules
Inserting
Fig. 6: Fitting a support rail in place
Fig. 7: Engaging the front end
5.4
Install glass door
AB69601en
Only change the configuration of the interior when
the device is switched off and is not loaded.
Note on the shelves
All shelves are supplied with the appropriate support
rails.
Only use the slide-in units with the associated sup-
port rails.
The standard shelves are held by support rails.
1.
Fit the support rail into the snap-in rail at the desired height at a
45 degree angle.
2.
Engage the support rail in a downwards direction.
3.
Fit the support rail on the opposite side.
4.
Insert the shelves into the support rails.
5.
Removing the shelves and support rails is done in the reverse
order.
The shelves are not secured with an end stop,
and can fall down if pulled out completely. There
is a risk of injury due to the shelf and load falling
down.
A glass door can be ordered and installed as an accessory.
Two people are required for the changeover.
02.2023 / Rev. --
CAUTION
Commissioning
21 / 82
Publicidad
