Publicidad
Idiomas disponibles
Idiomas disponibles
Commissioning
1
Fig. 4: Power supply connection
1
Mains cable socket
Other connections
2
Fig. 5: Other connections
1
LAN connection
4
Mains cable socket
5.3
Inserting and removing the slide-in modules
20 / 82
DANGER
A danger is posed by penetrating liquids.
There is an electric shock hazard for personnel.
−
If liquid has penetrated into the incubator, the
incubator must not be put into operation.
−
The incubator may only be operated at a socket
with a personal protection switch.
−
In such a case, contact a service technician of the
manufacturer.
NOTICE
There is a danger of damaging the incubator due to
an incorrect input voltage.
−
Before connecting the incubator, check the mains
voltage.
1.
Connect the supplied mains power cable to the power supply
socket on the rear of the incubator.
2.
Plug the other end into the main power outlet.
■
The installation should be protected by a 16A fuse and equipped
with a residual current device.
1
When changing the rails of the shelves, the rails on
the left and right sides must be at the same height.
02.2023 / Rev. --
Ensure the mains power supplies the correct
operating voltage as indicated on the rating
plate!
The mains cable must be freely accessible at
all times so that the incubator can be discon-
nected from the mains.
AB69601en
Publicidad
