Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
6.8
Programs
36 / 82
It has deliberately been made difficult to stop a Quick Program to
prevent the program from being stopped inadvertently. To stop a
program, you must go to the menu
and press and hold the STOP
and under-temperature protection is set automatically:
The over-temperature protection is the set temperature limit value of
+5°C, while the under-temperature protection limit is the set temper-
ature -5°C.
When the Quick Program is running, you can change the parameters
(temperature, fan and air flap) by pressing the
next time you start the Quick Program, your previous settings will be
saved.
After configuring the Quick Program, it appears in the list of pro-
grams. Quick Program is displayed at the top of the list by default.
Fig. 24: Quick program in program list
In Quick Program editing mode, you can change:
■
the data recording interval setting,
■
the protection class setting.
If the program is running, you can change the parameters (tempera-
ture, air flap position and fan speed (only for incubators with forced
air circulation)) by pressing icon
the Quick Program, your previous settings will be saved.
In this window, you can run the selected program, add a new one,
edit the program or delete it. The user can create 5 independent
programs.
Starting the selected program.
Stopping the program.
Adding a new program to the program list. The user can
create up to 5 programs.
Editing the selected program from the list.
02.2023 / Rev. --
, click on the program window
button for five seconds. Over-
or
icon. The
or
. The next time you start
AB69601en
Publicidad
