Publicidad
Idiomas disponibles
Idiomas disponibles
4 CONTROL PANEL
4.1 INTRODUCTION
The control panel is located on the upper front part of the UPS.
Through the panel, it is possible to check the general state of the UPS, batteries and related
alarms. The panel contains an LCD screen (which indicates the UPS operation status,
measurements and alarms) and a red EPO pushbutton located on the left of the display.
The display shows text messages and operating parameters on an LCD screen with four lines
and twenty characters per line. The screens are organized into six multilevel menus, which can
be selected using the membrane buttons below the LCD display.
There are two LEDs on the left side of the screen; a green one called "NORMAL" and a red one
called "ALARM". The LED actions are summarized in
Status
GREEN LED
RED LED
Figure 4.1: HMI located on the front of the equipment
Table 4.1: Summary of the HMI LEDs
UPS OK
On
Off
Table 4.1 on page
33.
Alarm Present
Off
On
Control Panel
No Alarms
On
Flashing
Enterprise | 33
Publicidad
