Publicidad
EOI'
TIME FADE
lars\ollarem@lUie-10ta, =
Desired Time
A
You can end play with fading out by
designating the play duration. Once the
time fade is set, it functions twice for editing
both sides of a tape. You can change discs
without cancelling this function and use it in
any play mode.
Note that you cannot use the time fade
function, when the DIGITAL OUT
(OPTICAL) jack is used for connections.
1 Press EDIT/TIME FADE three times in
stop mode (or press it once in pause
mode).
"TIME FADE" and "A" in the tape
indicator appear in the display.
2 Set the desired play duration, using
either numeric buttons or
</> Pi.
A When setting the time for one 'eo
side or the tape as you wish
a | '
Use numeric buttons.
It is generally not necessary to press
numeric buttons for seconds if the
seconds you specify are 00.
B When using commercial tapes
(46-, 54-, 60-, 74-, and 90-minute
tapes)
Each time you press <4 P41, the
play duration for one side of the tape
appears as follows.
HALF DISC -—~ C-46-— C-54-— C-60
123.00 ewmr
127
OD em
630.00 wer)
[ veee puoi
aul
14S
00 RM
197
OQ
3 Press > to start playing.
After the desigantd time, play fades out
and pauses. "8" in the tape indicator
lights up.
To start play for the other side of
the tape
Press > or ll.
The unit enters pause mode at the set time
by fading out for a specified duration.
When this play ends, time fade is cancelled.
To cancel time fade
Press EDIT/TIME FADE again.
Time fade is also cancelled when
<< of BP is kept pressed.
To display the time remaining until
the set time
Press TIME twice.
When play ends within the designated period
Time fade function 1s kept active Change discs
and start play. When the total playing time of the
discs reaches the designated period. the unit
pauses by fading out.
Publicidad
