Lowara GEMK Serie Instrucciones Para La Instalación Y El Uso página 112

LEDs and controls
1 2
12.6 12.6
ALARM 63
1 01/01/2010
TEST
4
1
1 12.6 12.6
ALARM 63
2
01/01/2010
3
9.4 Installation
Carefully read all the accompanying documentation before beginning installation.
Installation must only be performed by qualified personnel familiar with the EN12845 standard. Install the electrical panel in a
dry area observing the limits to use and ensuring that the data on the rating plate is correct for the use to which the electric
panel will be put.
9.5 Connections
The connection to the diesel pump electrical line and accessories must be made by qualified personnel that has been trained to
use the machine according to the indications on the attached wiring diagram and current regulations.
Before powering the panel with Vac alternating current, the wires connecting the starting battery must
ATTENTION be connected; failure to observe this indication could cause faults to the electric power unit which will
not be recognised by the manufacturer.
RPM/H MODE
2900 AUTO
10.00.00
PROG
3 2
ENTER
4 5
2
RPM/H MODE
2900 AUTO
10.00.00
Description:
1- LCD Display
2 - Signals:
Switch not in automatic, RED
Motor no start, RED
Pump running, RED
Controller fault, RED
3- Control button
4- Test button, YELLOW LED
GF002_A_SC
Description, display:
1 - Battery voltage level
2 - Alarms and messages
3 - Calendar – dd/mm/yy – hour/min/sec
4 - Revolution counter – engine hour counter
5 - Operating mode
112