Publicidad
–
+
ELEC
INDICATION SYSTEM
Fuel level gauge
1. Check:
Fuel level gauge
G
Not operating → Replace the multi-
function meter.
Checking steps:
Supply DC 12 voltage to the white
G
four-pin connector (+: red, –: black)
with a battery.
Disconnect the green two-pin connec-
G
tor (white/blue and black leads).
Connect the white/blue and black ter-
G
minals with a jumper lead 1.
G
Connect the green and red terminals
with a jumper lead 2.
NOTE:
If the jumper lead is installed for more
than 30 seconds, the display will auto-
matically turn off.
Check the fuel level segments is full
G
indicated.
G
Remove the jumper lead from the
green two-pin connector.
G
Disconnect the jumper lead 2 and
then connect it to green and red termi-
nal again.
G
Make sure the fuel low level segment
3, fuel level warning indicator 4,
"
" message 5 and "WARNING"
lamp 6 blink and the buzzer sounds
intermittently.
7-37
E
Publicidad
Capítulos
