Descargar Imprimir esta página

Yamaha WaveRunner XLT800 Manual De Servicio página 386

Ocultar thumbs Ver también para WaveRunner XLT800:

Publicidad

+
ELEC
INDICATION SYSTEM
Speed meter
1. Check:
Speed meter output voltage
G
Within specification → Check the speed
sensor output voltage and pulses.
Out of specification → Replace.
Speed meter output voltage:
10.5 V
Checking steps:
Supply DC 12 voltage to the white
G
four-pin connector (+: red, –: black)
with a battery.
G
Disconnect the blue one-pin connector
1 and make sure the "WARNING" lamp
lights 2.
NOTE:
If the "WARNING" lamp does not light,
disconnect the battery and then recon-
nect it.
Measure the voltage on the speed
G
sensor connector (white three-pin
connector) between the red/white
and black leads.
7-40
E

Publicidad

Capítulos

loading