Publicidad
FUEL
1
2
1
OIL PUMP
2. Adjust:
G
Oil pump cable
Adjustment steps:
G
Loosen the locknut 1 and the adjust-
ing nut 2.
G
Fully close the carburetor throttle
valves.
Adjust the oil pump cable so that the
G
mark a on the oil pump lever is
aligned with the mark b on the oil
pump body.
Tighten the adjusting nut and locknut.
G
Oil injection pump air bleeding
1. Bleed:
Air
G
Air bleeding steps:
Place rags around the air bleed screw
G
1 to catch any oil that might spill.
G
Fill the oil tank with the recommended
oil.
NOTE:
If the oil pump is replaced or the oil suc-
tion hose is reinstalled, bleed air from
the oil suction hose by removing it from
the oil pump.
After bleeding the air, reconnect the
hose with a locking tie.
Recommended engine oil:
YAMALUBE 2-W or an
equivalent TC-W3 certified
outboard oil
Loosen the air bleed screw 1 two full
G
turns and make sure that both the oil
and air bubbles flow out.
When there are no air bubbles left,
G
tighten the air bleed screw.
Wipe up any spilt oil.
G
4-30
E
Publicidad
Capítulos
