Publicidad
JET
PUMP
a
BEARING HOUSING
b
2
1
Oil seal installation
1. Install:
Oil seal
G
Driver rod:
YB-06071/90890-06606
Bearing outer race attachment:
YB-06156/90890-06626
NOTE:
Before installing the oil seal, lubricate the
clip glove with water resistant grease.
Distance a:
6.8–7.2 mm (0.27–0.28 in)
2. Install:
Intermediate drive shaft
G
Distance a:
9.5–10.5 mm (0.37–0.41 in)
NOTE:
Support the intermediate housing with
steel blocks 1 and press the driven cou-
pling shaft.
3. Install:
G
Oil seal 1 [8 mm (0.31 in)]
Oil seal 2 [10 mm (0.39 in)]
G
Distance a:
10.3–10.7 mm (0.41–0.42 in)
Distance b:
1.6–2.0 mm (0.06–0.08 in)
6-25
E
Publicidad
Capítulos
