Publicidad
FRONT WHEEL AND REAR WHEEL
5 - 7
8. Tighten:
• Bolt (axle holder) 1
23 Nm (2.3 m · kg, 17 ft · lb)
NOTE:
Before tightening the bolt, fit the wheel axle to
the axle holder by stroking the front fork sev-
eral times with the front brake applied.
Rear wheel
1. Install:
• Bearing (right) 1
• Circlip 2
New
• Spacer 3
• Bearing (left) 4
• Oil seal 5
New
NOTE:
• Apply the lithium soap base grease on the
bearing and oil seal lip when installing.
• Install the bearing with seal facing outward.
• Use a socket that matches the outside diam-
eter of the race of the bearing.
• Right side of bearing shall be installed first.
• Install the oil seal with its manufacture's
marks or numbers facing outward.
CAUTION:
Do not strike the inner race of the bearing.
Contact should be made only with the outer
race.
CHAS
Publicidad
Capítulos
