Publicidad
FRONT FORK
21. Measure:
• Distance a
Out of specification → Turn into the lock-
nut.
Distance a:
18 mm (0.71 in) or more
Between damper rod 1 top and
locknut 2 top.
22. Loosen:
• Rebound damping adjuster 1
NOTE:
• Loosen the rebound damping adjuster finger
tight.
• Record the set position of the adjuster (the
amount of turning out the fully turned in posi-
tion).
23. Install:
• Push rod 1
• Fork spring 2
NOTE:
• Install the fork spring with the damper rod 3
pulled up.
• After installing the fork spring, hold the
damper rod end so that it will not go down.
24. Install:
• Spring seat 1
• Cap bolt 2
NOTE:
Fully finger tighten the cap bolt onto the
damper rod.
25. Tighten:
• Cap bolt (locknut) 1
NOTE:
Hold the locknut 2 and tighten the cap bolt
with specified torque.
5 - 36
CHAS
29 Nm (2.9 m · kg, 21 ft · lb)
Publicidad
Capítulos
