Publicidad
Idiomas disponibles
Idiomas disponibles
S S e e t t u u p p
Stryker Endoscopy considers instructional training, or inservice, an integral part of the 1588 AIM
Camera. Your local Stryker Endoscopy sales representative will perform at least one inservice at
your convenience to help set up your equipment and instruct you and your staff on its operation
and maintenance. To schedule an inservice, contact your local Stryker Endoscopy representative
after your equipment has arrived.
Setting up the 1588 AIM Camera involves three steps:
1. S S e e t t t t i i n n g g u u p p t t h h e e c c o o n n s s o o l l e e
2. S S e e t t t t i i n n g g u u p p t t h h e e c c a a m m e e r r a a h h e e a a d d
3. S S e e t t t t i i n n g g u u p p t t h h e e c c o o u u p p l l e e r r
W W A A R R N N I I N N G G - -
•
Always connect the console to an appropriate power source, using a hospital-grade power
cord. Loss of AC power will cause the camera to shut down and the surgical image to be lost.
•
Only connect items to the 1588 AIM Camera that have been specified for use with the camera
system. Connecting incompatible equipment may cause unexpected results.
•
When the camera system is used with other equipment, leakage currents may be additive.
Ensure that all systems are installed according to the requirements of IEC 60601-1.
•
Equipment which employs RF communications may affect the normal function of the 1588 AIM
Camera. When choosing a location for the camera system, consult the Electromagnetic
Compatibility section to ensure proper function.
•
Always set up the console in a location that allows adequate ventilation (airflow) to the
console. Insufficient ventilation may cause the console to overheat and shut down.
S S e e t t t t i i n n g g U U p p t t h h e e C C o o n n s s o o l l e e
Refer to the instructions below and the wiring diagram on the following page for a typical
1588 AIM Camera configuration.
1. Connect the console's AC power to a hospital-grade outlet.
2. Connect one of the console's DVI outputs to an available DVI input on a Stryker digital capture
console such as the SDC3 (0240–060–100).
•
The 1588 AIM console can also be connected to additional SDC video inputs or directly to
one or more display monitors; the rear panel provides one analog and two digital-video
outputs:
O O u u t t p p u u t t T T y y p p e e
Analog
Digital (standard)
P29924F
O O u u t t p p u u t t
C C a a b b l l e e
S-VHS 1*
S-VHS
DVI-I1** and
DVI
DVI-I2**
C C o o n n n n e e c c t t o o r r
4 pin Mini-Din
(push-only connectors)
29 pin (push-only
connectors, with two
tightening knobs)
11
EN
Publicidad
