PIAGGIO Vespa 125 1955 Manual Para Estaciones De Servicio página 176

•
Fig. 57
Substitution of the steering column cover.
Sustituci6n del cubre direcci6n.
146
having previously drilled oversaid spots to a depth
of 0,7 to 1 mm. with a 6 to 7 mm dia. drill to weaken
them). After having removed the component, place
the new pre - drilled part in position, and usin� it
as a template, drill the corresponding holes in the
windshield and then rivet in position.
SUBSTITUTION OF MUFFLER SECURING RING NUT
For this substitution proceed as fol lows :
Saw the exhaust pipe in proximity to the ring nut.
Slide off the existing ring nut and replace a new
component.
Reweld the sawn pipe with new ring nut in po­
sition.
If necessary file down the weld cord.
SUBSTITUTION OF HANDLEBAR SLEEVE ( for Vespa
125 /VNB 3 - Vespa 150 /VB l - VBA - VBB - Vespa
G.L. except Mod. VLA 1 - Vespa G. S.).
a) Dismantling ( fig. 58 /A).
Dismantle the speedometer, headlamp, dip switch,
contemporaneously disconnecting the relative wi­
ring.
Disconnect the front brake cable ( at both ex­
tremities) and throttle control cable; slide out