Controls On The Right Side Of The Handlebar - APRILIA SR 50 Uso Y Mantenimiento

CONTROLS ON THE RIGHT SIDE OF THE HAN-
DLEBAR
NOTE
The electrical parts work only when the ignition switch is
in position " ".
NOTE
The lighting system works only when the engine is run-
ning.
1) LIGHT SWITCH ( - •) (
When the light switch is in position " • ", the lights are off; when
the switch is in position "
beam are on.
1a) LIGHT SWITCH ( -
When the light switch is in position " • ", the lights are off; when
the switch is in position "
lights are on; when it is in position "
parking lights are on.
1b) DIMMER SWITCH ( -
countries where the engine stop switch "
quired)
When the dimmer switch is in position "
the parking lights are on; when it is in position "
beam and the parking lights are on.
NOTE
The lights can be switched off only by stopping the
engine.
1c) ENGINE STOP SWITCH (
(in the countries where required)
WARNING
Do not operate the engine stop switch "
conditions.
not provided)
", the rear parking light and the low
- •)
" the low beam and the parking
" the high beam and the
) (not provided for those
- " is re-
", the low beam and
", the high
- )
- " in running
1
This is a safety or emergency switch. With the switch in position
" ", it is possible to start the engine; the engine can be stopped
by moving the switch to position "
CAUTION
With stopped engine and ignition switch in position "
battery may run down.
When the vehicle has come to a halt, stop the engine, and
move the ignition switch to position "
2) START PUSH BUTTON (
When the start push button is pressed and one of the brake
levers (front or rear) is activated at the same time, the starter
makes the engine run.
For the starting procedure, see p. 32 (STARTING).
1a
1b
1c
2
".
", the
".
)
use and maintenance SR 50
17