Installing The Rear Mudguard Extension; Removing The Rear-View Mirrors - APRILIA SR 50 Uso Y Mantenimiento

3
4
INSTALLING THE REAR
MUDGUARD EXTENSION
Carefully read p. 39 (MAINTENANCE).
Raise the saddle, see p. 19 (UNLOCK-
ING / LOCKING THE SADDLE).
Take the rear mudguard extension (1) out
of the crash helmet/glove compartment
together with the screws and relevant nuts
provided for the fastening.
Correctly insert the clip (2) in the appro-
priate seat (3).
Position the rear mudguard extension (1)
inside the number plate holder support (4).
Tighten the screw (5).
Insert the three screws (6) and tighten the
relevant nuts (7).
2
5
7
1
In the countries where required: work-
ing from the inner side of the number plate
holder, insert the bulb socket (8).
Make sure that the rear mudguard exten-
sion (1) is positioned correctly.
6
1
8
9
11
12
10
REMOVING
THE REAR-VIEW MIRRORS
Carefully read p. 39 (MAINTENANCE).
The following information refers to one rear-
view mirror only, but is valid for both.
Position the vehicle on the centre stand,
see p. 38 (POSITIONING THE VEHICLE
ON THE STAND).
NOTE
Group the components of the left
and right rear-view mirrors separately.
Remove the cover (9).
CAUTION
Hold the rear-view mirror (10), to prevent
it from accidentally falling down.
Unscrew the screw (11).
Remove the rear-view mirror (10).
Remove the gasket (12).
use and maintenance SR 50
53