Power Unit
$
%
!
5-44
2.
1 1
15) Inspection of Exhaust Cover
1.
16) Removing Crank Case
1.
#
'
&
"
Remove engine anode 1 and check it.
Replace it if it is reduced to 2/3 of the original
size.
Check the removed exhaust cover for damages such as
distortion or scratches on its mating surface.
Remove clogs and debris from cooling water
passage of exhaust cover.
Loosen crank case mounting bolts in the order shown,
remove them, and remove crank case.
When removing crank case, pry the gap at the
groove of crank case by using a bladed screw
driver.
Note that there are two knock pins on the mating
surface of crank case.
GB
2st X18E2 2012