Inspection Items; Draining Gear Oil; Removing Propeller - TOHATSU EverRu MX 18E2 Manual De Servicio

Lower Unit
5
6
7
1 Split pin
2 Propeller nut
3 Washer
4 Propeller
5 Thrust holder
6 Propeller shaft
7 Propeller shaft housing
6-12
4
1
2
3
4

3. Inspection Items

1) Draining Gear Oil

1. Drain gear oil. Refer to "Replacement of Gear Oil" in Chapter 3.
· Drain all gear oil, and check if any metal particle
is found in the drained oil.
· Check gear oil color. White or cream color
possibly indicates that water is contained in the
gear oil.
· Note the above matters and use them as a
reference if disassemble is required.

2) Removing Propeller

· Before removing or installing propeller, be
sure to remove stop switch lock plate.
· When removing or installing propeller, do
not handle propeller with bare hands.
· Put a piece of wooden block between anti-
cavitation plate and propeller to prevent
rotation of propeller when removing or
installing propeller.
1. Shift gear into neutral (N).
2. Put a piece of wood between anti-cavitation plate and
propeller 4 to prevent the propeller 4 from accidental
rotation. Pull out split pin 1, loosen propeller nut 2, and
then, propeller 4.
WARNING
2st X18E2 2012
GB