TOHATSU EverRu MX 18E2 Manual De Servicio página 286

Lower Unit
OBM OBM
OBM
OBM OBM
OBM
1
6-46
2
1342
1342
4
3
31) Assembly of Propeller Shaft Housing
1. Check that OBM grease is applied to housing ass'y oil seal.
2. Attach washer and propeller shaft ass'y to propeller shaft
housing ass'y.
3. Apply grease to new O-ring.
Apply grease to push rod 1 and install them to propeller
4.
shaft 2.
Attach propeller shaft housing ass'y 3 to gear case, and
5.
tighten bolts 4 to specified torque.
· Use grease to prevent push rod from falling
from propeller shaft.
· When installing housing ass'y to gear case,
tighten upper and lower bolts in 2 or 3 steps
evenly to specified torque.
Propeller Shaft Housing Bolts 4 :
6 N · m (4 lb · ft) [0.6 kgf · m]
1342
1342 1342
GB
2st X18E2 2012