Descargar Imprimir esta página

TOHATSU EverRu MX 18E2 Manual De Servicio página 44

Publicidad

Idiomas disponibles

Idiomas disponibles

Service Information
1 High Tension Cable
1-22
6. Test Run
1.
Start engine and check if gear shift can be made
smoothly.
2.
After warming up the engine, read tachometer to check
idling engine speeds specified below.
RPM
3.
Shift gear into forward (F) and at idle slow for
approximately 10 minutes.
RPM
4.
Run at 3,000 r/min or half of WOT for initial 2 hours, then
at 4,000r/min or 3/4 of WOT for 1 hour.
1
1
5.
Check that shifting into reverse (R) will not tilt up outboard
motor and allow water to run into boat.
7. Checks After Test Run
1.
Check that no water is present in gear oil.
2.
Check that no fuel leaks in the cowl.
3.
Check that no oil and water leak in the cowl and no water
is present in engine oil.
4.
After test run, use flushing kit or flushing attachment and
fresh water to wash cooling water path by idling engine.
(Refer to P.3-10.)
Idling Speed :- Neutral
950 r/min
Tachometer :
P/N. 3AC-99010-0
Trolling Speed :- Shift in
800 r/min
Complete test run during break-in operation.
Gear oil turns to creamy white if mixed with water
invading into gear case.
GB
2st X18E2 2012

Publicidad

Capítulos

loading