Selecting The Ultimatte Main Unit - Blackmagic Design Ultimatte 12 Manual De Operaciones

You can always assign additional units by clicking on the 'Ultimatte' menu at the top of the
screen and selecting 'Ultimatte Connection'.
You can see all the Ultimatte units being controlled by glancing at the status bar. Up to 8 units
can be controlled, and each unit icon will illuminate green when identified on your network.
When a unit is selected for control, the icon will illuminate blue. For more information on how to
set up and control multiple units over a network, refer to the 'connecting to a network' section.
Refer to the 'connecting to a network' section for information about how to set up and control multiple Ultimatte
units on your network
TIP
If your Ultimatte is connected to your computer or Smart Remote 4 but its unit
indicator is not illuminated in the status bar, check your IP settings are configured
correctly. Refer to the 'connecting to a network' section for more information.

Selecting the Ultimatte Main Unit

If you are connected to more than one Ultimatte unit over a network, you can switch between
the unit you want to control by clicking the corresponding unit number in the Ultimatte
Status bar. You can also use the F1-F8 keys on your computer's keyboard to switch between
connected Ultimatte units.
If using a Smart Remote 4 to control more than one Ultimatte, use the 'units' buttons on the left
hand side to select the Ultimatte you want to control. Tapping the numbers in the status bar will
launch the connection dialogue box.
When selected, the unit icon will illuminate blue and all controls will be visible.
Ultimatte Software Control 27