Blackmagic Design Ultimatte 12 Manual De Operaciones página 396

Ocultar thumbs Ver también para Ultimatte 12:

Tabla de contenido

Idiomas disponibles

Matte Density: 0 ↵

Red Density: 0 ↵

Green Density: 0 ↵

...(Full list in Controls section)

The client may request that Ultimatte load, save, delete, or rename a file. To load a file the client

should send the following block:

Load: <filename> ↵

Ultimatte will respond with an ACK followed by a Current File block or a Message block.

To save, delete, or rename a file the client should send one of the following blocks:

Save: <filename> ↵

Delete: <filename> ↵

Rename: <filename> ↵

To: <filename> ↵

In each case Ultimatte will respond with an ACK followed by a File List block or a

Message block.

GPI Event List

The client may request that Ultimatte add, insert or remove an event to a GPI Event List by

sending an Insert GPI Event or Remove GPI Event command, followed by a blank line.

For example, to insert an event, the client should send the following block:

Insert: <filename> ↵

At: -1 ↵ {The insertion index. A '-1' represents the end of the list}

To remove an event a client would send the following block:

Remove: 1 ↵ {Event index to remove. A '0' will delete all events}

To set the current event index a client would send the following block:

Developer Information

Tabla de contenido