Rack Installation - Blackmagic Design Ultimatte 12 Manual De Operaciones

Rack Installation

Ultimatte 12 8K and 4K models can be installed into a broadcast rack or road case using
the included Ultimatte rack mount kit.
If you are using your Ultimatte on a desk, you can fit the supplied rubber feet to the base.
Simply stick a rubber foot to each corner of the underside, taking care not to cover any screws.
The rack mount kit contains the following items:
2 x Front Rack Ears
Attach the front rack ears to the outside
front edge of the unit.
2 x Rear Rack Ears
Attach the rear rack ears to the outside
rear edge of the unit.
2 x Chassis Bumpers
Two chassis bumpers can be attached to
each side of the chassis. These bumpers
are designed to protect the rear connectors.
They can also provide strain relief for cables
that are connected to the unit.
Screws
12 x M4 Countersunk 6 x M4 Flathead Screws
For front rack ears For rear rack ears
and chassis bumpers
Rack Installation 80