Blackmagic Design Ultimatte 12 Manual De Operaciones página 83

3 Using the supplied M3 5mm countersunk screws, mount the device to the rack.
4 Once you've installed your HyperDeck or other Blackmagic Design product, turn the
rack shelf right side up and install into your equipment rack.
Blanking panels can be used to fill spaces in your rack that may be left available, such as when
mounting a HyperDeck Studio HD Mini with a Blackmagic Web Presenter.
To attach the 1/6 blanking panel:
The 1/6 blanking panel is designed to be attached to 1/2 rack width products, such as
HyperDeck Studio HD Plus when they are mounted solo, or with a 1/3 rack width product such
as a Blackmagic Web Presenter. Mount the panel to the side of the device towards the center
of the rack to allow for airflow between units.
1
Remove the 5mm M3 screw near the front
of the device.
To attach the side 1/3 width blanking panel:
To install the 1/3 width blanking panel, line up the screw holes and anchor point with the shelf.
The 1/3 width blanking panel can be used on either side or the center of the rack. Screw the
panel to the shelf using two of the supplied M3 5mm countersunk screws.
For deeper products, such as the Blackmagic Studio Converter, use the Blackmagic Universal
Rack Shelf.
2
Line up the blanking panel and attach using the
supplied M3 10mm nylon screw.
Rack Mounting 83