Riester RVS-100 Manual Del Usuario página 76

field strength in the location in which the monitor is used exceeds the applicable RF compliance level above, the monitor should
be observed to verify normal operation. If abnormal performance is observed, additional measures may be necessary, such as
reorienting or relocating the monitor
b. Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
Recommended separation distances between portable and mobile RF communications equipment and the
The monitor is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The
customer or the user of the monitor can help prevent electromagnetic interference by maintaining a minimum distance between
portable and mobile RF communications equipment (transmitters) and the monitor as recommended below, according to the
maximum output power of the communications equipment.
Rated maximum
output power of
transmitter
(W)
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can
be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of
the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection
from structures, objects and people.
Warning:
M
• This product needs special precautions regarding EMC and needs to be installed and put into service according to the
EMC information provided. This unit can be affected by portable and mobile RF communications equipment.
Do not use a mobile phone or other devices that emit electromagnetic fields near the unit. This may result in incorrect
•
operation of the unit.
Caution:
This unit has been thoroughly tested and inspected to assure proper performance and operation.
•
• This machine should not be used adjacent to or stacked with other equipment. If such positioning is necessary, this
machine should be observed to verify normal operation in the configuration in which it will be used.
76
EQUIPMENT or SYSTEM – for EQUIPMENT or SYSTEM that are not LIFE-­SUPPORTING
Recommended separation distances between
portable and mobile RF communications equipment and the Q3 monitor
Separation distance according to frequency of transmitter
150 kHz to 80 MHz
=
d 2 . 1 P
0.12
0.38
1.2
3.8
12
(m)
80 MHz to 800 MHz
d P
=
2 . 1
0.12
0.38
1.2
3.8
12
35
800 MHz to 2.5 GHz
d P
=
3 . 2
0.23
0.73
2.3
7.3
23