Publicidad
Idiomas disponibles
Idiomas disponibles
Important safety information
Installation safety
WARNING
To reduce the risk of fire, electric shock, personal injuries, and/or death, observe the following
precautions.
• Have your range installed and properly grounded by a
qualified installer, in accordance with the installation
instructions. Any adjustment and service should be
performed only by qualified gas range installers or
service technicians.
• Do not attempt to service, modify, or replace your range or any part of your range unless
it is specifically recommended in this manual. All other service should be referred to a
qualified technician.
• Always use new flexible connectors when installing a gas appliance. Do not use old
flexible connectors.
• Make sure the Anti-Tip device is properly installed on the range.
See the installation instructions for more information.
• Due to the size and weight of the range, have two or more people move the range.
• Remove all tape and packaging materials.
• Remove all accessories from the cooktop, oven, and/or lower drawer.
Grates and griddles are heavy. Use caution when handling them.
• Make sure no parts came loose during shipping. Do not install in an area exposed to
dripping water or outside weather conditions.
• Make sure your range is correctly installed and adjusted by a qualified service technician
or installer for the type of gas (natural or LP) you will use.
For your range to utilize LP gas, the installer must replace the 5 surface burner orifices and
2 oven orifices with the provided LP orifice set, and reverse the GPR adapter.
These adjustments must be made by a qualified service technician in accordance with
the manufacturer's instructions and all codes and requirements of the authority having
jurisdiction. The qualified agency performing this work assumes the gas conversion
responsibility.
10 English
• Installation of this range must conform with local codes or, in the absence of local codes,
with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest edition.
In Canada, installation must conform with the current Natural Gas Installation Code,
CAN/CGA-B149.1, or the current Propane Installation Code, CAN/CGA-B149.2, and with
local codes where applicable. This range has been design-certified by ETL according to
ANSI Z21.1, latest edition, and Canadian Gas Association according to CAN/CGA-1.1, latest
edition.
Location safety
WARNING
To reduce the risk of fire, electric shock, personal injuries, and/or death, observe the following
precautions.
• This range is for indoor, household use only.
Do not install the range in areas exposed to the
weather and/or water.
• Do not install the range in a place which is exposed
to a strong draft.
• Select a level, well-constructed floor that can
support the range's weight. Synthetic flooring,
such as linoleum, must withstand 180 °F (82 °C)
temperatures without shrinking, warping,
or discoloring. Do not install the range directly over
interior kitchen carpeting unless a sheet of ¼ inch
plywood or a similar insulator is placed between the
range and carpeting.
• Select a location where a grounded, 3-prong outlet is easily accessible.
• If the range is located near a window, do not hang long curtains or paper blinds on that
window.
• Do not block or cover the vents (air openings) located at the rear of the range and at the top
and bottom of the door. The vents allow for air circulation that is necessary for the range to
operate properly with correct combustion. Blocking or covering the vents may cause incorrect
combustion which could result in gas leaks and fire.
• Make sure the wall coverings around the range can withstand heat up to 200 °F (93 °C)
generated by the range.
Publicidad
