Samsung NSY6 855 Serie Manual Del Usuario página 47

Gliding Rack
Gliding racks may be cleaned by hand with an abrasive cleaner or steel wool. During cleaning,
be careful not to allow water or cleaner to enter the slides of the rack.
To lubricate the slides
1. Remove the rack from the oven.
See removing the gliding rack in the USING
THE GLIDING RACK section.
2. Fully extend the rack on a table or countertop.
Newspaper may be placed underneath the
rack for easy cleanup.
3. If there is debris in the slide tracks, wipe it
away using a paper towel.
(Any graphite lubricant wiped away must be
replaced - See steps 4 through 7.)
4. Shake the graphite lubricant before opening
it. Starting with the left (front and back) slide
mechanism of the rack, place four (4) small
drops of lubricant on the two (2) bottom
tracks of the slide close to the bearing
carriers.
5. Repeat for the right (front and back) slide
mechanism of the rack.
6. Open and close the rack several times to
distribute the lubricant.
7. Replace the cap on the lubricant and shake it
again. Turn the rack over and repeat steps 3,
4, 5, and 6.
8. Close the rack, turn rack right-side-up and
place in the oven. See installing the gliding
rack in the USING THE GLIDING RACK section.
NOTE
Do not spray the gliding rack with cooking spray
or other lubricant sprays.
English 47