Samsung NSY6 855 Serie Manual Del Usuario página 18

Cooktop
Ignition
CAUTION
The knob LED indicates if a burner knob has been turned on.
It does not indicate if the burner flame is on.
Check for an actual flame, whether the knob LED is on or off.
3
1
1
2
Manual ignition
If there is a power failure, you can ignite the burner manually. Use caution when doing this.
1. Hold a long gas grill lighter to the surface burner you want to light.
2. Push in the control knob for that burner, and then turn it to the Lite position. Turn on the
grill lighter to ignite the burner.
3. After the burner is lit, turn the control knob to adjust the flame level.
Flame level
The flames on the burners should always stay under the cookware, and should not extend
beyond the cookware bottom at any time.
18 English
Make sure all surface burners are properly
installed. To light a burner:
1. Press the button integrated into the knob.
2. While pressing the button, push in the control
knob and then turn it to the Lite position.
You will hear a 'Clicking' sound indicating the
electronic ignition system is working properly.
3. After the surface burner lights, turn the
control knob to shift it out of the Lite position
and turn off the electronic ignition system.
4. Turn the control knob to adjust the flame
level.
WARNING
• Flames larger than the cookware bottom may result in a fire or physical injury.
• When you set a burner to simmer, do not turn the burner knob quickly.
Watch the flame to make sure it stays on.
• After turning on a surface burner, make sure that the burner has ignited even if the knob
LED is on. Adjust the level of the flame by turning the burner knob.
• Always turn off the surface burner controls before removing cookware.
All surface burner controls should be turned off when you are not cooking.
• Always turn the burners off before you go to sleep or go out.
• If you smell gas, turn off the gas to the range and call a qualified service technician.
NEVER use an open flame to locate a leak.
• If you set and use the knob button of precision knob, the original safety function does not
work normally.
• If the knob LED illuminates, but the surface burner does not ignite, turn off the control
knob immediately.