Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Burner grates and components
Turn off all surface burners and make sure they have all cooled down.
L L
C C
R R
1
2
3
8
7
6
50 English
1. Remove the center burner grate(C) following
both sides grates.(L/R)
2. Remove the burner caps from the burner
heads.
3. Remove the burner heads from the valve
manifolds to reveal the starter electrodes.
4. Clean all removable grates and burner
components in warm, soapy water.
Do not use steel-wool pads or abrasive
cleaners.
5. Rinse and dry grates and burner components
thoroughly.
6. Return the burner heads to their positions on
top of the manifold valves. Make sure a starter
electrode is inserted through the hole in each
burner head.
NOTE
See the next page for detailed burner component
re-assembly instructions.
7. Return the burner caps to their positions on
top of the burner heads. To ensure proper and
safe operation, make sure the burner caps lie
flat on top of the burner heads.
8. Reinstall the burner grates in their respective
positions.
9. Turn on each burner and check if it operates
properly. After verifying that a burner
operates normally, turn it off.
Brass burner head
CAUTION
• The starter electrodes are not removable. Do not attempt to remove them by force.
• To avoid chipping, do not bang grates and caps against each other or against hard
surfaces, such as cast iron cookware.
• The burner head can be blocked by food or dust. Clean the head if it appears blocked.
If you clean the head with water, assemble it only after it is completely dry. If the head is
wet, it might prevent the burners from igniting.
• To avoid falling down the grates, make sure to remove both sides grates first.
• Do not attempt to remove center oval burner cap from the head.
NOTE
• The brass parts of your burner will change
color with use. However, this will not affect
performance and you can clean the brass
parts with a brass cleaner.
• After cleaning, confirm that the burner port
openings aren't plugged.
• Shake out any excess water and then let
burner heads and caps dry thoroughly. Placing
the center burner upside down will allow the
water to drain out more easily.
• Do not wash any burner components in a dish
washer.
Publicidad
