Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Information codes
Code symbol
Meaning
Oven sensor malfunction.
The oven is overheating.
Check the Control PBA NTC Sensor.
Check the PBA NTC Sensor.
Check the PBA NTC Sensor.
Check the cooling system.
Control pad malfunction.
Door lock malfunction.
PCB signal malfunction.
Touch IC and PCB signal malfunction.
Oven vent blocked.
62 English
Solution
1. Tap Stop, and then restart the oven.
2. If the problem persists, disconnect all
power to the oven range for at least
30 seconds and then reconnect the
power.
1. If oven vent or cover air is blocked
by aluminum foil or others,
remove that and restart oven.
2. To reset error, disconnect power
or tap Stop after opening the
oven door at least 60 seconds.
Code symbol
Meaning
Gas leakage in the gas connection
section.
Divider switch malfunction.
** If these solutions do not solve the problem, contact a local Samsung service center or
call 1-800-SAMSUNG (1-800-726-7864).
Solution
1. Disconnect power. Open the back
cover. Check there are signs of
combustion in the gas connection
section.
2. If there are signs of combustion,
replace GPR and TCO and check
the gas leakage.
3. If there are no signs of
combustion, check wire-TCO, Wire
main - sub connection status and
PBA S/W version.
1. If the Divider is in the oven, make
sure it is pushed in all the way.
2. If the Divider is not in the oven,
see if something is pressing
against the divider switch in the
back of the oven.
3. If the Divider is all the way in or
there is nothing pressing against
the Divider switch, Tap Stop,
and then restart the oven. If the
problem persists, disconnect
all power to the oven range for
at least 30 seconds, and then
reconnect the power.
Publicidad
