Programming And Operation: Pre-Set Programs - Orved Сuisson 31 Manual De Uso

OPERATION

9.5 PROGRAMMING AND OPERATION: PRE-SET PROGRAMS

When you use the pre-set programs with gas option enabled, make sure the food gas system is present and connected
as described in Chapter 7 – section 6. To choose the correct mixture, consult your usual gas supplier.
Proceed as follows:
1) Select the desired program with the UP/DOWN buttons:
POSIT.
21°
22°
23°
24°
25°
26°
27°
28°
29°
30°
31°
32°
33°
34°
2) Program the sealing if a value other than the default setting is required:
PhASE DESCRIPTION
1
Select the pre-set program required.
Enter programming mode by pressing PROG for 3 seconds.
2 The display shows SEALING associated with the default value or with the value
set previously.
3 Press PROG briefly to select SEALING.
Change the value. A number of LEDs that are proportional to the sealing value
4
are activated/deactivated
5 Confirm the value with PROG or exit programming with STOP.
3) lower the lid to start the cycle; at the end of the cycle the lid opens automatically.
4) Interruption of the cycle: pressing the STOP button at any time, the machine immediately stops the cycle and the
chamber is decompressed.
48
Rev. 01 - 03/2018 - Cod. 1500024 - Instruction manual for vacuum chamber packaging machines for vacuum cooking mod.
PROGRAM NAME
VEGETAblES
MEAT
ChICKEN
fISh
bAKERy PRODUCTS
DESSERTS
fRESh PASTA
flOUR
SPICES
ClEANING Of MUSSElS
AND ClAMS
GAS WAShING lIGhT
SWEET PREPARATION
GAS WAShING INTENSE
SWEET PREPARATION
PRESERVATION
COOKING
GAS fUNCTION ACTIVATED
×
×
×
×
×
KEy
Cuisson