Codificación En Función Del Equipamiento; Option-Related Coding; Antes Del Montaje; Before Installation - Moeller IZM Manual De Instrucciones

Interruptor automático
Ocultar thumbs Ver también para IZM:
Tabla de contenido

Publicidad

19.2.2 Codificación en función del equipamiento
El interruptor automático y el dispositivo extraíble se pueden equipar
posteriormente con una codificación en función del equipamiento.
De este modo, el interruptor y el dispositivo extraíble pueden asignarse
sin que haya confusiones, teniendo en cuenta los diferentes equipa-
mientos. Si el interruptor y el dispositivo extraíble tienen codificaciones
distintas, no será posible enchufar el interruptor.
Hay 36 posibilidades de codificación seleccionables.

Antes del montaje:

- Desconectar y destensar el resorte de acumulación de
energía (a página 24-2)
- Retirar el interruptor automático del dispositivo extraíble
(a página 24-3)
Incorporar la codificación en el interruptor
1
(1)
Codificadores
(2)
Placas de codificación
(3)
Tornillo de cabeza con hexágono interior M5 con arandela y
tuerca
(4)
Tornillo avellanado M5 con tuerca cuadrada
Para IZM(IN).3-...:
- Monte la placa de codificación horizontalmente a la inversa
- Para la sujeción sólo se requieren los dos tornillos sin las
tuercas ni las arandelas.
10/02 AWB1230-1407E/GB

19.2.2 Option-related coding

Circuit-breakers and withdrawable units can be retrofitted with a ver-
sion-related coding.
In this way, the circuit-breaker and the withdrawable unit can be
assigned to each other unmistakably considering different equip-
ment. If the circuit-breaker and the withdrawable unit have a diffe-
rent coding, it will not be possible to rack in the circuit-breaker.
There are 36 selectable coding possibilities.

Before installation:

- Switch off and discharge the storage spring
(a page 24-2)
- Remove the breaker from the withdrawable unit
(a page 24-3)

Fitting coding on circuit-breaker

Tam. / Size
2
4
6 Nm
(1)
Coding pins
(2)
Coding plate
(3)
Hexagon socket bolt M5 with strain washer und nut
(4)
Countersunk-head bolt M5 with square nut
For IZM(IN).3-...:
- Mount coding plate in horizontally mirrored position
- For fixing, only the two bolts are required without nuts and
washer
3
5
4
PZ 2
6 Nm
19 – 7

Publicidad

Tabla de contenido
loading

Tabla de contenido