Cleaning The Pot; Battery Change - WMF Perfect Ultra Manual Del Usuario

Ocultar thumbs Ver también para Perfect Ultra:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
keys (25)/(26). Otherwise the signal is sounded
another four times.
The pressure cooker can only be opened if it has
been fully depressurized. Only then the indicator
(24) on the timer (12) will change from red to
green (W). The indicator flashing in green (24)
will extinguish automatically after approxima-
tely 1 minute.
2.3. Removal of the timer
In order to remove the timer (12) simply
withdraw it in an upward direction from the
handle (X).
The earliest that you can remove the timer (12)
is at the start of the cooking time, that is, when
the preset heat setting has been reached and
the minute time display (21) is running. When
you remove the timer (12), the red indicator
extinguishes (24), but the minute display (21)
continues to run on.
On expiry of the preset time period, even with
the timer (12) removed, the signal is sounded
up to 5 times (see above). Then the indication
extinguishes.
During the cooking time the timer can be remo-
ved (12) and also replaced at any time.
A correction of the preset cooking time is only
possible, if the timer (12) is positioned on the
lid handle (5).
2.4. Notes on care and maintenance
Only use a moist cloth to wipe down the timer
(12) for cleaning.
Do not immerse in water and do not clean in
the dishwasher.

2.5. Battery change

The battery compartment is located to the rear
of the timer (12). Use a coin to open the com-
partment (Y). Place a battery into the battery
compartment in accordance with the polarity
specifications (Z). Lithium batteries of type
CR 2450, 3 volt, are required.
Use a coin to re-close the battery compart-
ment (Y).
3. How to use the pressure cooker
Before first use
3.1. Open the pot
Turn the rotary knob (8) to the position
»open/close« (30a) and pull it backwards (30b).
Pivot the lid handle (5) to the right until the in-
dicators on the lid and on the long handle are
aligned (B). Lift off the lid.

3.2. Cleaning the pot

Before first use, you should remove the labels
and wash all parts of your pressure cooker (see
Section on »Cleaning«).
Turn the lid over and detach the lid handle (5)
from the lid by pulling the orange slide (7) on
the underside of the handle (5) towards the end
of the handle as indicated by the arrow and
then lift off (C).
Remove the sealing ring (10) from the lid.
3.3. Closing the pot
Insert the handle (5) into the lid (D) and move
the orange slide (7) across the lid rim until it
audibly engages.
Insert the sealing ring (10) into the rim of
the lid.
Replace lid (see marking on lid and pot handle)
and turn lid handle (5) to the left until the stop
position has been reached (B).
Press rotary knob forwards (8) (A) and set to
the required heat setting 1 or 2 (30c)/(30d).
22

Publicidad

Tabla de contenido
loading

Tabla de contenido