Siemens SINAMICS G130 Manual De Listas página 916

Signal targets for STW1_BM
Signal Meaning
= ON (pulses can be enabled)
STW1.0
0 = OFF1 (braking with ramp-function generator, then pulse cancellation and ready-to-power-up)
1 = No OFF2 (enable is possible)
STW1.1
0 = OFF2 (immediate pulse cancellation and power-on inhibit)
1 = No OFF3 (enable possible)
STW1.2
0 = OFF3 (braking with the OFF3 ramp p1135, then pulse cancellation and power-on inhibit)
1 = Enable operation (pulses can be enabled)
STW1.3
0 = Inhibit operation (cancel pulses)
1 = Operating condition (the ramp-function generator can be enabled)
STW1.4
0 = inhibit ramp-function generator (set the ramp-function generator output to zero)
1 = Enable the ramp-function generator
STW1.5
0 = stop the ramp-function generator (freeze the ramp-function generator output)
1 = Enable setpoint
STW1.6
0 = inhibit setpoint (set the ramp-function generator input to zero)
STW1.7 = Acknowledge faults
STW1.8 Reserved
STW1.9 Reserved
STW1.10 1 = Control via PLC
STW1.11 Reserved
STW1.12 Reserved
STW1.13 Reserved
STW1.14 Reserved
STW1.15 Reserved
<1> Used in telegrams 220.
<2> STW1.10 must be set to ensure that the drive object accepts the process data (PZD).
<3> Interconnection is not disabled.
1 2
DO: SERVO, VECTOR
PROFIdrive - STW1_BM-control word metal industry interconnection
Interconnection
parameters
p0840[0] = r2090.0
p0844[0] = r2090.1
p0848[0] = r2090.2
p2816[0] = r2090.3
p1140[0] = r2090.4
p1141[0] = r2090.5
p1142[0] = r2090.6
p2103[0] = r2090.7
p0854[0] = r2090.10
<2>
<3>
<3>
<3>
<3>
3 4
[Function diagram] [Function diagram]
internal control word signal target
[2501.3] [2610]
[2501.3] [2610]
[2501.3] [2610]
[2501.3] [2634.3]
[2501.3] [3060] [3070] [3080]
[2501.3] [3060] [3070]
[2501.3] [3060] [3070] [3080]
[2546.1] [8060]
- - -
- - -
[2501.3] [2501]
- - -
<3> - -
- -
<3>
- -
<3>
<3> - -
5 6
fp_2425_54_eng.vsd
06.08.09 V04.03.01
<1>
PROFIdrive sampling time
Refer to [1020.7]
Inverted
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
7 8
Function diagram
- 2425 -
S120/S150/G130/G150